homestyle - Installation & User Guide

U S I N G Y OU R 3 Wa y T a p & T a n k

D I G I T A L T A N K O P E R A T I ON

LED Touch Controls - For instant hot water, touch and hold the blue LED handle for 3 seconds to remove the safety control. When the red light pulses you may press again and dispense near boiling water. After 10 seconds the control returns to the safe blue mode whereby the LED light is constantly blue.

A

The optional Crystal Clarity Filter can be installed on the incoming mains cold supply to provide filtered water on tap through your normal cold control. Ask your dealer for further details

B

H

G

Water Regulations & Requirements: It is important that the water connections to your tap comply with the water regulation requirements, plumbing code and good practice. It is good plumbing practice to install balanced and equal hot and cold pressures to the appliance in order to create a consistent flow of water. Water supplies should be from a common source, either mains or tank fed. If supplies are not balanced and equal pressures then a PRV valve should be fitted to the main cold supply inlet.

C

D

F

E

Water Pressures: The tap has been manufactured to operate within the tolerances below: Minimum cold water pressure 1.0 Bar - Maximum 3 Bar (Ideally 1.5 to 2 Bar)

It is essential that you install a pressure reducing valve if the pressures are greater than the manufacturers recommendations to bring the pressure in line with the above stated pressures. Excessive pressures could result in either the tap cartridge or the tank to be damaged or leak.

A : SETTING Temperature range required 75 - 98 degrees B : HEATING DISPLAY Pulses Red During Heating Mode C : ACTUAL Current Tank Temperature D : CONFIRM BUTTON Confirm Temperature Selected E : ON/OFF POWER DISPLAY BUTTON F : TEMPERATURE BUTTON Sets Required Temperature + or - G : ACTUAL TEMPERATURE INDICATOR Temperature Varies Not a feature on the units where a filter timer has been added. H : HOT Indicates The Tank Is Hot J : REQUESTED TEMPERATURE INDICATOR Set Between 75 - 98

ALWAYS CHECK INCOMING PRESSURES BEFORE INSTALLATION.

Care and Maintenance: Only clean the tap with a soft cloth and soapy water, rinse and dry after cleaning. DO NOT USE ABRASIVE BLEACH OR CHEMICAL CLEANERS, this will invalidate your guarantee. THESE INSTRUCTIONS ARE ONLY INTENDED AS A GUIDE. IF THERE IS ANY DOUBT YOU SHOULD CONTACT A CERTIFIED PLUMBING ENGINEER OR SERVICE AGENT AND AVOID USING THE HOT WATER TAP UNTIL IT HAS BEEN CHECKED AND INSPECTED.

( See F to adjust )

sales@ukhomestyle.com

ukhomestyle.com